Luxillum has provided an easy, convenient and affordable energy saving solution which provides energy savings of over 40% over the original power consumption. (benefits can reach up to 70% depending on application).

Luxillum E Tube Fluorescent Lighting is a revolution in the lighting industry which will enable the universally standard Fluorescent type light fitting (which has been manufactured unchanged using old technology for the past 100 years) to be upgraded to the latest 21 century technology with a simple tube replacement.

The new Luxillum Etube combines an inbuilt 21st century designed electronics control , a highly efficient T5 fluorescent tube and a high efficiency reflector in a simple fluorescent tube replacement.

Simply replace your old fluorescent light tubes with the “new” E Tube and immediately receive the benefits.

Instantly Reduce

• Power Consumption
• Greenhouse Gas Emissions
• Power Costs
• Maintenance Costs
• Waste materials – mercury disposal!!

Other benefits (but not so obvious) of the Luxillum E Tube Fluorescent Lighting include;

• Extended lamp and control gear life
• Reduced waste mercury
• Reduced maintenance costs
• Reduced air-conditioning capacity requirements
• Meaning still lower power costs and less green house gases

Cost savings in utilsing the Luxillum E Tube Fluorescent Lighting can be significant. On current installations both in Australia and Taiwan the average reduction in power consumption is around 40%. This represents a saving of $400 EVERY $1000 spent on lighting electricity bills. Savings on lower Air conditioning running costs would be additional to these savings.

Features of the T8 adaptor for existing T8 fluorescent tubes

• Built in electronic ballasts
• Same original sizes of the T8 fixture
• Attached to the replacement T5 tube
• T5 manufactured with effective light transmittance glass
• It fits in the original light fitting, with out requiring any modification and  provides an instant increase in brightness and efficiency

Installation of the T8 adaptor

• Simply remove the original fluorescent tube and starter from the fitting
• Now fit the Etube adapter into the tube slot
• The original magnetic ballast works as a filter and increases the electronic ballast's power factor
• Presto ! in 10 seconds you have doubled the efficiency of the old light fittings and increased the light output to boot !!